|
[1]
Put your hair into a ponytail, up high on your head or one on each side for two falls.
If you have lots of fly-aways or fine, thin hair, you can wet your hair down slightly, and use a gel or hairspray on your hair.
It will help hold the falls in place better.
|
|
[2]
Then take the synth ponyfall, and slide the elastic around your ponytail, so that it hangs underneath your real hair.
I have used a fall with Platinum Blonde, for constrast.
This way you can see how to attach them a little better.
|
|
[3]
Now make a little hole at the top with your fingers [between the elastic of your ponytail, and your head].
|
|
[4]
Then pull the synth ponyfall up through the opening, slowly to avoid snagging it.
Be sure not too pull it through all the way.
You want the little nubbin at the top inside the base of your ponytail, behind the elastic.
You want the elastic and the base of the fall to be hidden underneath your real hair.
|
|
[5]
Pull your real hair apart just a bit, to tighten the ponytail which will help to secure the nubbin inside your real hair.
|
|
[6]
Now wrap the elastic band that the synth fall is attached to, around your real hair ponytail.
The fall should just cascade down, covering your real hair.
Use some bobby pins, or hair pins to hold them in place better, and to
position the hair better.
|
Repeat the above steps for the second fall if you have a pair.